|
Posted by Jaime on May 18, 2008, 10:21 pm
Please log in for more thread options You have the IR receiver plugged into the PC?
If so, try using a different USB port, it should give the usual message
about "New Hardware found, installing, etc.."
--
James
Orlando (Goofy says "Hey!"), FL
> I have the mce ir kit but mce stil say that I have to connect the ir
> control?
>
> "Jaime" wrote:
>
>> You must have the MCE IR kit (remote/receiver/emitter) to use a cable/sat
>> box; otherwise MCE would have no method to control your box to change
>> channels. You cannot run through the setup without the IR stuff plugged
>> into
>> the PC.
>>
>> BTW, S-video, while better than other video inputs (like composite), is
>> not
>> digital, it is still an analog signal. It just breaks the signal into
>> separate signals to increase the quality.
>> --
>> James
>> Orlando (Goofy says "Hey"), Florida
>>
>> > most tv card have a s-video input. I use them to connect the
>> > digicorder,
>> > this
>> > is digital tv and better then analoog. In the software of the hardware
>> > suppliers hauppauge, pinnacle you can switsch from analoog tv to
>> > s-video
>> > but
>> > these program are not good. The problem is how can I switch in media
>> > center
>> > to the s-video channel. The satelite channel I see the s-video channel
>> > but
>> > by
>> > installation media center ask for infrared receiver from the satelite
>> > topbox
>> > and don't go further.
>>
>>
| 
XML Sitemap