|
Posted by Dana Cline - MVP on October 12, 2005, 11:19 am
Please log in for more thread options
Have you tried going thru MCE's TV Settings setup again? That might help.
What DVD decoder software (and version) are you using?
Catalyst 5.9 is the latest one, although I'm still happily using the 5.4
version.
Dana Cline - MCE MVP
> Hi I have a Shuttle Zen XPC ST62K computer with an ATI chipset (IGP 9100)
> and
> an ATI eHome Wonder TV Tuner all running under MCE 2005. It used to work
> fine
> (up until around June/05) but then I had a h/w problem with the fan, and I
> sent the computer back to be repaired/replaced. After receiving the new
> computer back (same model) I put my hard drive and Tuner back in but was
> unable to get MCE2005 to work properly. It complained about video
> drives/card
> etc. I proceeded to uninstall the ATI drivers and re-installed the latest
> drivers (Catalyst 5.9) and eHome 5.03 (1.17.24.231) and DVD decoder s/w,
> but
> still no success. Now I can get TV but I only seem to get channel 4
> (Rogers
> cable channel guide). All other channels are frozen, choppy, or black.
> Also
> most previously recorded shows cannot playback; screen is black. I have
> tried
> the old drivers (that I used to have working) but it complains about
> version
> incompatability. So my questions are:
>
> 1) What versions of drivers should I be running
> 2) What order should they be installed? i.e. Catalyst before eHome?
> 3) Should I be installing the full Catalyst 5.9 or should I be installing
> the smaller download (says Display Driver, Control Panel,GART Driver,
> South
> Bridge driver)?
>
> Any other ideas as to my problem?
>
> Do I need to totally re-build (re-install MCE, etc) from scratch to have
> any
> hope of success? I'm not sure my activation key will work now some of the
> h/w is new.
>
> Thanks,...Roger
| 
XML Sitemap