Do you have a question? Post it now! No Registration Necessary. Now with pictures!
August 3, 2010, 12:24 pm
rate this thread
I have this Laptop which has given up the ghost immediately two days
after its warranty expiring. To cut the long story short, I have
ordered another mobo. The original heat sink method for GPU on this
mobo is thermal pad which I think is very inefficient, causing lots of
laptop failure and HP has, I believe withdrawn this laptop from the
There is a gap of about 1mm between the GPU and heat sink, and the
surface of the heat sink is not flat for the obvious reason that it is
meant for thermal pad.
What alternative I have for cooling the GPU more efficiently ? Is it
possible to fill the gap with some thermal compound which would not
run or bleed. Or reduce the gap with a copper shim and use thermal
paste on either side. Resurfacing the original heat sink surface is
not an option.
Appreciate your thoughts on it.
- » Computer hands, with solid ON HD LED on a rare basis.
- — Previous thread in » Overclocking PC Components
- » amazing retro FSB overclock on old Prescott P4 3400MHz 478 Pin uPGA
- — Newest thread in » Overclocking PC Components
- » Setup DNS configuration for Mechanize get request
- — The site's Newest Thread. Posted in » PERL Discussions
- » Rayban and Oakley Up To 85% Off. For A Limited Time Only
- — The site's Last Updated Thread. Posted in » MySQL Database Forum