Do you have a question? Post it now! No Registration Necessary. Now with pictures!
- Posted on
- Powercolor X800XL and Abit NF7
August 18, 2005, 6:41 am
rate this thread
Re: Powercolor X800XL and Abit NF7
Should just fit if the RAM clips are in the closed position. Inserting or
removing RAM with the card in place will be impossible. You will have to
measure the card to make sure, less than 19.5 cm from the card mounting
bracket to the far end of the rear heatsink bracket on the back of the
card - measurements taken on my NF7-S v2.0 board - should see it fit.
- » amazing retro FSB overclock on old Prescott P4 3400MHz 478 Pin uPGA
- — Newest thread in » Overclocking PC Components