HPDV6000 beep codes and no display at startup

Do you have a question? Post it now! No Registration Necessary.  Now with pictures!

Threaded View
Hi everyone

My HP DV6000 Pavillion, at startup, only beeps like this:

One long followed by two short beeps.

I believe that this is therefore an issue with the graphics display,
and I'm lucky if after twenty minutes of pressing the on/off button
that the system shows up on the screen.

Any other ideas as I am tearing my hair out over this.  Also, I
thought it might help if I bought a new HDD for it, but couldn't find
an AT HDD anywhere.  Do they not sell them anymore?

:)  Please help.

Re: HPDV6000 beep codes and no display at startup

Hey buddy how are you :)

Did you install the HDD?
if you did then you better check if your Ram's are installed in a
correct way(you have to apply a a bit of a force and you have to hear
the clicking sound when you install them)

I hope what i said will help you out :)

Good luck buddy


Site Timeline