Do you have a question? Post it now! No Registration Necessary. Now with pictures!
- Posted on
April 8, 2007, 2:45 am
rate this thread
standoffs,help?Inside the case where you sit the motherboard there is
rounded metal about half inch high where you put your standoffs.then
you set your motherboard on them and its to high,you can not put i/o
sheild on does not fit.The standoffs make it to high.Has anyone have
this problem.I have no i/o shield now,will that cause a problem.Poor
Re: Ultra Wizard Steel Mid-tower ATX PC Case Black.Can not use standoffs
Agreed, though beware of the standoff on the left side, 2nd
from the bottom - some boards may not allow for it so
hopefully the case doesn't have that position permanently
stamped out into a mount, or if it does, put a couple pieces
of insulating material over it like a square of plastic
secured with electrical tape.
- » Built new computer need help on a couple of things.
- — Previous thread in » Home-built Computers