Do you have a question? Post it now! No Registration Necessary. Now with pictures!
- Posted on
- Network problems after converting to NTFS
- Gerry Wolf
March 24, 2006, 11:25 pm
rate this thread
computer to NTFS and all seemed to go well. Except for the fact that the
network is basically toast! I have a three system network and after the
conversion, I cannot access anything from either system. I tried to run
network setup, but that failed to do anything.
I did check to see if he could print using the printer connected to the
network and that was no problem, so what's with the file access? The error
message reads as follows:
***** is not accessible. You might not have permission to use this network
resource. Contact the administrator of this server to find out if you have
Access is denied
Since I am the administrator, what do I do now?
Thanks for the assistance.....
- » Exasperating graphics problem, motherboard related?
- — Next thread in » Home-built Computers