Do you have a question? Post it now! No Registration Necessary. Now with pictures!
- Henri Beyle
August 26, 2009, 9:50 pm
rate this thread
Few months ago I asked herr how to connect 2 POwer UNit into 1 case in
order to start&stop them with the front panel button.
Paul told me about the wire thing. While looking for something else, I
find this :
No reason no to try it now !
THanks guys ! :-)
Re: How to connect 2 P.U.
On Wed, 26 Aug 2009 23:50:37 +0200, Henri Beyle
Hmm, ok but all you need is a $2 pack of crimp wire splices
from the hardware store, just trim out the blank at the end
of one channel in each and connect green-green and
black-black. If the cables are already long enough to do
that, it cuts down on additional cabling in the case, and
lowers contact resistance by omitting the 2nd set of
connectors in series.
Even so, it's nice to see someone makes something like this
adapter cable kit but I hate to think what it'll cost (in
total, delivered) for just three connectors and a few feet
of wire between them. I'll take a guess... $18?