Do you have a question? Post it now! No Registration Necessary. Now with pictures!
- Posted on
- wireless mouse failure - Model No. PB-WB1
August 20, 2005, 7:44 pm
rate this thread
is not .. new batteries .. tried changing channels .. no joy
The light on the transmitter is on.
This mouse was connected with a ps2 to USB adaptor when it just stopped
I plugged it straight into a USB port to see if that would make the
difference there was no change ..
I tried updating the driver through device manager .. it went through the
motions and now registers a USB mouse in device manager but it still does
When I press the only button on the transmitter the light starts flashing
but there is no other change.
Re: wireless mouse failure - Model No. PB-WB1
Did you know that there is a button situated on the receiver pod and one
under the mouse itself. Apparently these two units have to be synchronized
(So I was told at PCWorld). Connect everything up and press the button on
the underside of the receiver unit (the one connected to your PC) the LED
should flash. Now whilst the mouse is within range and with known good
batteries in it, press and hold the button on the underside of the mouse
after a few seconds the flashing LED will speed up and you should have
communication and hopefully it will work.
thanks to kev_in at the Packard Bell forum
- » Wattage date for graphic cards. Would ati radeon all-in-wonder 8500 or 7500 work in 230W P...
- — Next thread in » Computer Hardware
- » Yellow Bang in Device Manager for USB, Why? Help Please.
- — Previous thread in » Computer Hardware