Do you have a question? Post it now! No Registration Necessary. Now with pictures!
- Posted on
February 20, 2007, 4:56 pm
rate this thread
the 200 gig one. The 160 drive doesn't show up in My Computer. So I
don't know how to access the drive. The computer hardware lists the
drive as being installed and not having any problems. both drives are
listed in the bios as master and slave on IDE channel 0. The primary
drive shows in My Computer and is operational, it is the other drive
that doesn't show. I ran the WD diagnostic and both drives "passed."
Any ideas on how I can access the drive?
Re: Slave drive -- Computer says it is there but it doesn't show in My Computer
It was a drive I was using as an external drive. I decided to use it
internally. It was partitioned and has data on it. I haven't haven't
done anything to the dirve or the pc other than intalling the drive in
the pc and hooking up the wiring.
- » Newest MemTest86, MemTest86+ incompatible with Sandy, Ivy chipsets?
- — Next thread in » Computer Hardware