SCSI bus scan locking

Do you have a question? Post it now! No Registration Necessary.  Now with pictures!


I've attached an autoloader to an Adaptec SCSI adapter, but when system
reboots and rescans the bus, the it locks up at ID4 (the autoloader). I
disconnected the cable SCSI cable, then went into the SCSI Select utility
(Dell PowerEdge server) and reconnected the cable and suddenly the
autoloader is found when I run a scan in SCSI Select. FYI, I already have an
internal tape drive installed.

I've not had much experience with SCSI so would appreciate any suggestions.


Site Timeline