Do you have a question? Post it now! No Registration Necessary. Now with pictures!
- Posted on
- New hardware...oh no it isn't!
January 29, 2007, 12:34 pm
rate this thread
every time I switch the printer on I get the 'Found new hardware' message.
I just close it, and the resulting warning, and it works. But how can I stop
it showing the new hardware message?
On a similar subject I have also installed a wireless card (Netgear WG311T)
and wireless modem/router (Netgear DG834GT), and on boot I get the Netgear
config wizard every time. Similarly I close this, and it works ok. But
again, how can I stop it opening the wizard unnecessarily?
Windows XP Pro SP1
Gigabyte GA-VTXE 1.0 motherboard
AMD 1.4 Althon XP processor
1 Gb RAM
Radeon 8500 graphics card
Re: New hardware...oh no it isn't!
Probably, you didn't (fully) finish the installation.
Insert the driver media, go to the device manager, select update
driver. And be a little more patient, before you remove the
(Especially if a reboot is part of the installation procedure.)