Do you have a question? Post it now! No Registration Necessary. Now with pictures!
- Posted on
- HyperX Timings and BIOS settings - help?
April 21, 2006, 10:56 pm
rate this thread
I've my 4 x 512 C2 GeIL memory sticks to Kingston HyperX (KHX3200AK2/2G
CL2). My mobo is Gigabyte GA-K8NS Ultra-939 with F10 BIOS. CTRL-F1 and i can
manually set all DDR timings. HyperX works as 3-3-3-8 at 2.6V and 2-3-2-6 at
2.65. Mobo in auto settings recognizes DDRs as 3T. I've increased voltage
0.2V from standard voltage but it doesn't help. When I manually set 2T I get
blue BSOD during system (Windows XP) startup. So i've tried with 2.5T and it
seems to work. But the problem is that M.I.B. (MB Intelligent Tweaker) has a
lot of timing options more than simple "2-3-2-6" and I'm not sure how I
should set it. Could you help me? Using google didn't help me.
Re: HyperX Timings and BIOS settings - help?
Toms Hardware did a review recently that compared timings vs. FSB
speeds. Based on that, I would say that your faster timings are likely
to give you marginal benifits, perhaps between 1-5%. If it were me, I'd
just leave it auto and not worry about it. It would be easier to get
that 5% boost from increasing the FSB 15MHz or so.
- » how do I chop out a piece of a sting surrounded by two hex codes?
- — The site's Last Updated Thread. Posted in » PERL Discussions