Do you have a question? Post it now! No Registration Necessary. Now with pictures!
May 13, 2005, 8:24 pm
rate this thread
On Fri, 13 May 2005 20:24:53 +0000, DM wrote:
Try holding down the Insert key before and during power up.. You may
need to disconnect the AC cord for 15 seconds first.
Abit KT7-Raid (KT133) Tbred B core CPU @2400MHz (24x100FSB)
My server http://wesnewell.no-ip.com/cpu.php
Verizon server http://mysite.verizon.net/res0exft/cpu.htm
As another poster remarked, hold down the "Insert" key while you power up
the system. That is supposed to cause it to boot using the default BIOS
If that doesn't work (it probably will), clear the CMOS settings. There's a
jumper near the button cell that maintains the CMOS settings. Turn off the
power to the system (unplug it if your power supply has no switch), change
the jumper from pins 1 and 2 to 2 and 3. Wait a few seconds, then move it
back. Apply power again, and the system should boot in the default BIOS
settings. (You may need to go into the BIOS setup immediately and make some
setting changes if you're using RAID.)
All this is in the manual, which is available for download from
www.abit-usa.com if you've mislaid your original copy.
Address scrambled. Replace nkbob with bobkn.