|
Posted by drfabs on December 13, 2006, 3:47 pm
Please log in for more thread options
John,
I also have a VIP622 and I am not able to get any tv signal through media
center. I have used a coxial cable from the box to a computer in another
room. It appears that the coax cable on the VIP622 uses channels higher than
the channel scanned in media center. How did you get yours to work?
Mark
"JOHNFDS" wrote:
> Media Center 2005 with all updates, Dish Network ViP622 HD-DVR / Satellite
> Reciever w/its remote, and a MS MCE Remote Control. The TV Tuner setup in
> MCE is unable to recognize the ViP622's remote and the MS MCE Remote is
> unable to change channels on the ViP622 with an emitter attached to the
> middle of three IR sensors on the ViP622. Read where someone changed their
> selection during MCE setup from a maximum 4 digit channel numnber to 3 digits
> and it worked but I guess there were other issues not to mention 999 would be
> the highest channel MCE would access.
> Help,
> John.
| 
XML Sitemap