|
Posted by Paul Webster on August 3, 2006, 8:06 am
Please log in for more thread options wrote:
>
>> To: Paul Webster
>>>> My Tungsten C has been working well, but would not turn on
>>>> at all when I tried to use it a couple of hours ago. The
>>>> light comes on when it is placed in the cradle but all else
>>>> is dead. There is no response when the Reset button is
>>>> pushed. I tried Reset and the power switch together but
>>>> don't know if I have the right sequence for a hard reset. Is
>>>> there any other reset function?
>>
>>An in-cradle reset, set the PDA in the hotsync cradle and push the reset
>>button. This should reset the charging circuits.
>No obvious immediate effect when I try that here. However, I have done
>it and am leaving it on the cradle to see if it springs back into life
>later in the day.
Well - it did spring back into life after I left it charging overnight
following the in-cradle reset.
Thanks for that tip.
--
Rgds
Paul Webster
| 
XML Sitemap