|
Posted by Jeffrey - GzmDesign on September 10, 2007, 3:55 am
Please log in for more thread options I don't use active sync anymore cos i'm runing vista, but i do remember that
there was an option inside ActiveSync that you could tell it not to start
with windows, but i could be wrong...
--
Cheers
Jeffrey
info@gzmdesign.com
www.gzmdesign.com
>I know that i can use msconfig to remove wcescomm.exe from autostart. But
> process wcescomm.exe everytime is used overwrites my setting and put
> itself
> to startup again.
>
> "Jeffrey - GzmDesign" wrote:
>
>> You can always start it manually, if you run "msconfig" (without the "")
>> on
>> the run dialog (Start - Run) and then go to startup or services you will
>> find it there and you can remove it from the startup process, and then
>> you
>> only have to run it from the file, you can make a shortcut in your
>> desktop
>> and run it manually after the computer boots up fully.
>>
>>
>> Hope it helps!
>> Cheers
>>
>> Jeffrey
>> info@gzmdesign.com
>> www.gzmdesign.com
>>
>>
>> > When my computer boots up activesync checks the serial port before it
>> > is
>> > created/opened by bluetooth driver. This causes error that activesync
>> > wants
>> > again configure serial port, because cannot join to previously created
>> > one
>> > jet.
>> >
>> > Is there any possibility to start process wcescomm.exe after btdrivers
>> > are
>> > completly loaded?
>> >
>> > Can be unactivated dialog for setting com/irda port when previously set
>> > com/irda cannot be connected. (Port is loaded after this dialog appears
>> > and
>> > is normaly working. It is annoyng cancel this dialog everytime i start
>> > up
>> > my
>> > computer.)
>> >
>> > Can be startup of activesynt (wcescomm.exe) delayed? (To gain some time
>> > for
>> > BT drivers loading)
>> >
>> > Can be set off autostart of wcescomm.exe? (This process automatically
>> > set
>> > autostart for itself when is started)
>> >
>> >
>> > I use a widcomm BT drivers.
>> >
>> > Thanks
>> >
>> >
>> >
>>
>>
| 
XML Sitemap